Any Hull Cleaners here?

First post. Just curious.

Views: 1765

▶ Reply to This

Replies to This Discussion

Permalink Reply by A.. Parnell on November 29, 2010 at 8:42pm
You bet Mike my first commercial job back in 1970 Marina Del Rey, Ca. three years of hard work then graduated to hyd machines.
Permalink Reply by sean blesi on August 20, 2012 at 12:22pm

Any suggestions on what type  hydraulic hull cleaning equipment ?

Permalink Reply by steve henshaw on December 2, 2010 at 5:10am
yes me and still doing it.
just lashed out on a new machine ooouuuuucchhhhhhhhhh£££££$$$$$$.
i just hope it does what it says on the tin
Permalink Reply by sean blesi on August 19, 2012 at 9:13pm

Hi Saw and old post. I hull clean by hand and want to start prop polishing on big props.  I also want to use the hydraulics on mega yachts.

 

Any suggestions on equipment-powerpacks, brushes, heads etc..

 

Thanks

Permalink Reply by Skylar on December 2, 2010 at 1:32pm
divers or machines?
yachts or ships?
Permalink Reply by A.. Parnell on December 2, 2010 at 2:11pm
both
Permalink Reply by steve henshaw on December 3, 2010 at 6:05am
both but ref ships BIG ones we only prop polish
Permalink Reply by Barone on December 16, 2010 at 2:54pm

yes, I have hull cleaned every Navy ship in the pacific fleet,and polish screws with DS brushes on nuclear sub's in the pacific fleet. When I was younger use to clean pleasure crafts to in SD harbor. I would have to say most all divers have clean a hull or two in there time.

Permalink Reply by sean blesi on August 19, 2012 at 9:16pm

saw your old post.  i clean boats by hand but want to start polishing props and clean bigger yatchs and ships if possible- any suggestions on equipment like powerpacks, brushes, and heads to run brushes?

im looking at armada hull

 

Thanks

Permalink Reply by steve henshaw on August 28, 2012 at 7:04am

i looked at that kit but it its big brush head wise, so i opted for smaller head more $$$ but you get into smaller spaces.

power pack is briggs stratton powered 10 to 40ltrs per min 160bar max good kit quite too.

unlike my cavi blaster that wakes the dead and its honda, it ok and does the job just about for the cost and its limited applications.

Permalink Reply by sean blesi on August 28, 2012 at 8:24am

Hi Steve

Thanks for the reply. 

So do you have the small head from Armada?  Where can I get a small head? Where did you get the Briggs & Stratton?  Where do you get your brushes?

I want a power pack that will just do the job-dont need all bells and whistles and so much power to light a city!!

Any suggestions too on power pack?

Thanks

Sean

Permalink Reply by A.. Parnell on August 28, 2012 at 12:21pm

Try to get a honda engine you will be better off in long run.

RSS

NEW Commercial Diving Jobs

© 2024   Created by Adam Broetje.   Powered by

Badges  |  Report an Issue  |  Terms of Service