cDiver.net
The Commercial Diver Network
Good gloves for U/W Welding using Hot water?
Hi welders,
Any suggestions for a good gauntlet glove to use for U/W welding in cold water with a hot water suit setup? We used to get a decent glove from Divex but they don't seem to supply them anymore. I am thinking about a big rubberized or Nytril overglove that might be fairly tough and at least last a week or so. Lot's of work at the waterline in surge = lots of shocking fun... Attached is a diver photo with the current gloves.. Suggestions?
Thanks in advance.
Any suggestions for a good gauntlet glove to use for U/W welding in cold water with a hot water suit setup? We used to get a decent glove from Divex but they don't seem to supply them anymore. I am thinking about a big rubberized or Nytril overglove that might be fairly tough and at least last a week or so. Lot's of work at the waterline in surge = lots of shocking fun... Attached is a diver photo with the current gloves.. Suggestions?
Thanks in advance.
Views: 513
- Attachments:
-
-
IMG_0268.JPG, 110 KB
-
Replies to This Discussion
-
Permalink Reply by Simon on
-
Try the Showa 660 gloves, fisherman wear them. Good for burning too. If you are in cold water get a bigger size and wear a pair of 2mm superstretch neoprenes under them. Cost about £4 in the UK.
-
Permalink Reply by Keith W. Fisher on
-
If possible clean it the best you can, like they stated below, I have used hydraulic wire brush cleaners. I use a pair of those super high voltage lineman gloves. Don't forget to tell topside to make it cold...
-
Permalink Reply by matthew chrysanthus on
-
Dont waste your money. The thick chemical gloves at tractor supply. $5 . For hot water suits. The way to go. With yhour latex gloves as well of course
- ‹ Previous
- 1
- 2
- Next ›
© 2025 Created by Adam Broetje.
Powered by
